Tracking Failures in Silicone Rubber Insulators? Deionized Precipitated Silica IOTA FINE SIL 7523

Hits: 1929 img

Electrical insulation is where high-performance silicone rubber earns its premium. Insulators, bushings, cable accessories and encapsulated electronics all depend on the compound staying a good dielectric for years — in humidity, pollution and heat. When a finished part tracks, flashes over or shows unstable dielectric behavior, the review usually starts with the polymer or the curing system. Often the decision was made one step earlier: the grade of precipitated silica used as reinforcement.

Why filler quality decides insulation

Precipitated silica is made in aqueous process, and ionic residues — sulphates, iron and other soluble salts — remain in the powder. Inside a silicone compound these residues raise the ionic conductivity of the polymer phase. Under wet and contaminated service conditions, higher ionic content means higher leakage current, faster tracking and less stable electrical performance.

Ordinary reinforcing grades (such as IOTA FINE SIL 7365 and 7518) are engineered for mechanical performance: tensile strength, tear resistance, cost-effective replacement of fumed silica. They do that job well. But when the compound must also behave as an insulator, the purity of the filler becomes a specification of its own.

What deionized treatment changes

IOTA FINE SIL 7523 is deionized-treated precipitated silica, positioned for high-performance and high-demand silicone rubber. Published specification:

Property

IOTA FINE SIL 7523

SiO2 (dried)

≥90%

BET surface area

200–220 m²/g

Particle size

5 μm

pH value

6.5–7.5

Moisture

4–8%

Sulphate

≤0.5%

Iron content

≤200 mg/kg

Treatment

Deionized

Package

White kraft paper bag, 15 kg/bag

Compared with IOTA FINE SIL 7365 and IOTA FINE SIL 7518, grade 7523 gives better diaphaneity, better appearance and color, and better insulation performance. The lower sulphate limit (≤0.5% vs ≤1.0%) and the tighter iron limit (≤200 vs ≤300 mg/kg) are exactly the numbers that matter when the compound works as a dielectric.

Three grades, three jobs — choose by the failure mode

  • Mechanical reinforcement first, transparency second → IOTA FINE SIL 7365 / 7518 (BET 200–220 m²/g, Fe ≤300 mg/kg)
  • Highest transparency, appearance and color demand → IOTA FINE SIL 7360 (8 μm, BET 180–200 m²/g)
  • Insulation-critical and appearance-critical compounds (insulators, bushings, electronic encapsulation, light-colored premium parts) → IOTA FINE SIL 7523

A practical selection rule: list which failure hurts most — mechanical failure, visible whitening, or electrical tracking — and let that pick the grade. Mixing time, loading and cure system stay the same; the filler grade is the variable.

How to evaluate 7523 in your compound

  1. Run a side-by-side compound with your current reinforcing grade, same formulation and mixing conditions.
  1. Compare volume resistivity and dielectric strength before and after humidity aging, not only on dry samples.
  1. Check transparency and post-stretch whitening on cured slabs.
  1. Review the cost position: deionized precipitated silica still replaces fumed silica at a fraction of the price.

The full datasheet of IOTA FINE SIL 7523 is published on iotasilica.com. Samples are available for testing — feel free to reach out.

Online QQ Service, Click here

QQ Service

What's App